Voltera Community
Log In
Technical Support
About the Technical Support category
(1)
Conductor 3 vs 2 Brittleness/Adherence
(5)
Print height issue since update
(2)
Pogo Pins that connect the probe or drill to the V-One
(9)
Is it possible to factory reset the V-One
(4)
Add lid when baking so that energy loss is reduced?
(2)
Pads melt when hand soldering
(4)
Replacement parts
(2)
How to fix clogged nozzles?
(
2
)
(21)
Print output deteriorating
(13)
Probe Connector Problem
(3)
Better Clamp Plate Design?
(9)
Rheological Setpoint Question
(1)
Conductive ink keeps going out
(2)
Clogging? or soldification of ink during long printing
(1)
Unable to move to back (y-min), switch did not trigger. Calibraiton/home failure
(2)
Circuit extends beyond printable area
(7)
BGA on Voltera-one
(2)
Mirroring for printing Bottom Paste
(20)
Extra lines and circles added to pads
(4)
Voltera PCBs in vacuum chamber
(1)
Breaking needles
(9)
[Solved] - How to zoom (magnify) in the software?
(5)
Remove piston from used cartridge & Setup to print uniform ink thickness
(2)
Printing setting recommendations for a customized material
(1)
Computer does not detect Voltera. It stuck on `Scanning for Printers`
(4)
How to stop heater plate wiggling
(2)
Paste head leaking after print?
(2)
First paste print has gaps?
(4)
Measure height slight problem with holes
(3)
next page →
Product
Docs
FAQ
Contact
Store