Voltera Community

Technical Support

Remove piston from used cartridge & Setup to print uniform ink thickness (2)

Computer does not detect Voltera. It stuck on `Scanning for Printers` (4)

How to stop heater plate wiggling (2)

Paste head leaking after print? (2)

First paste print has gaps? (4)

Measure height slight problem with holes (3)

Anti-stringing distance causes error? (2)

Reflow not working? (1)

Calibration possible problem? (1)

Drill is blocked (2)

Error: unable to calculate probing targets for solder paste (2)

Please add option to continue in spite of "risk of nozzle crash" (4)

Software not printing all paths in certain geometry (5)

OK to print first layer *before* drilling? (3)

Printer does not want to update (2)

Cannot drill anymore since last update (3)

Impossibility to align properly (3)

What am I doing wrong with the clamps? (17)

Problem with Drill Files in Voltera V-One Software (2)

Voltera not aligning correctly (2)

Is it normal for the machine to whine excessively when the motors are enabled? (18)

The chips are not always adequately soldered mystery (10)

Supplier and Spec for PET (3)

Calibration failed; z-switch not triggering (5)

Connector Family Suggestion (for those w/out drill attachment) (2)

Clean Needles after printing (4)

Solder problems (6)

Warning on 2.5 Update (4)

Print & drill hole misalignment (3)

Keystoning hell and pads that are not flat (7)

Powered by Discourse, best viewed with JavaScript enabled