Community
Log In
Feature Request
About the Feature Request category
(1)
Ink cartridge for custom etching
(1)
Ability to save a group of settings by name
(5)
Documentation on Print Settings
(3)
Solder paste board rework
(2)
Alignment probing after simple outline
(4)
Z axis control durring alignment probing
(3)
Be able to load the Top layer as a solder mask
(2)
Watch the probe between interactions, or add a re-home button
(5)
Ink calibration pattern moveable
(1)
Silkscreen/white ink option enable
(6)
No fly zones over the board
(14)
Eurocard support
(3)
Getting started Kit - add a few drill bits
(4)
Ability to rotate circuit before printing
(4)
Developing Linux Drivers
(4)
V-Two Wish List
(1)
Enhancements to Aligned Print mode
(4)
Auto pad/feature centre detection
(5)
Adjust probe height and speed when outlining/positioning over pads
(9)
Move artwork by x/y units during positioning/outline step
(3)
Alignment for both top and bottom prints
(8)
Percentage Complete when loading gerbers
(3)
next page →
FAQ
Product
Forums
Support
Contact
Store
