Check files to see why no holes show up?

[a2retro]

LEDTester.TXT (579 Bytes)
LEDTester.cmp (7.2 KB)
LEDTester.sts (721 Bytes)

I would like to use 4 pre-plated holes as positioning markers for the rest of the circuit?

[troy]

@a2retro! good to see you!

I tried loading using this: http://viewer.tracespace.io/, failed there too.

To get the circuit to render I had to tweak the format settings of the drill file to:

• zero suppression: leading (was trailing)
• coordinate places: 2, 5

…meanwhile, the cmp file uses: 3, 4. That’s probably the problem. Our app expects the coordinates in the drill file to match the gerber file.

Can you try tweaking the export settings and see if that resolves the issue?

• Troy

[a2retro]

Hi Troy, Thanks for checking!

I might have mixed some job files up. I will start over with the Voltera job and check the files again.

Thank you for the quick response. Voltera’s support is always top notch!

[a2retro]

Well I regenerated the files with a fresh Voltera.cam file and the files are identical? No I am not sure whats going on - using Eagle 8.4.2

[a2retro]

Hi any further suggestions?

[mewertow]

Hey @a2retro, did you get a chance to try the export settings @troy suggested?

zero suppression: leading (was trailing)
coordinate places: 2, 5

[troy]

Sorry about that @a2retro, I was away last week, then sick most of this week. I’ll take another look tomorrow, if matt doesn’t beat me to it.

[troy]

in the meantime, you could try loading the cam file checking/overriding the drill format settings.

If you can send us your brd (post here or email to support@voltera.io), we can try it here.